Sony PCG-GRX700 - Manual (Page 108)

Connecting a Port Replicator
You can connect a port replicator to the computer while the computer is on or off. Connecting a port replicator while the
computer is in a power saving mode (Standby or Hibernate) may result in data loss or a computer malfunction.
You can use the AC adapter or battery to power the computer while it is connected to a port replicator. However, your
system consumes battery power faster if multiple devices are attached to the port replicator. See
Using the Battery for
more information.
Moving the computer with the port replicator attached could disconnect the AC adapter or power cord, and may cause
the computer to lose power or malfunction.
To connect a port replicator
1. Close active programs to prevent data loss.
2. Turn off the computer, and disconnect all attached devices (including the AC adapter).
3. Close the tilt stands on the computer.
You can charge the battery by installing it before you connect the port replicator. The battery automatically
charges once you connect the AC adapter.
4. Slide open the port replicator connector cover to expose the connector.
5. Align the connector on the bottom of the computer with the port replicator connector, and gently push the
computer down until it clicks into place.
Connecting an AC Adapter to a Port Replicator
6. Plug the AC adapter into the DC IN port on the port replicator, and plug the power cord into the AC adapter and
an AC outlet. The power indicator turns on.
Connecting a Port Replicator
7. Make sure the port replicator is securely fastened to the computer.
8. Turn on the computer.
Page 108