Sony FWD-32LX1R - Manual (Page 39)

39
(GB)
Setting the Security Lock / Setting an IP address and communication speed
3
Enter the password again for re-confirmation.
Re-enter new password key.
Be sure to remember this password.
Use : Cancel : Other key MENU ENTER
The setting is finished when the following
message appears.
If “Invalid password!” appears on the menu
screen, start the procedure again from Step 1.
INITIAL SETUP/INFORMATION
Language:
Color System:
Auto Shut Off:
Security Lock:
Information
All Reset
Invalid password!
English
Auto
Off
Off
Set ENTER Exit MENU Select
4
After completing the process described above,
turn off the display unit and unplug the power
cord to make the setting valid.
The Security Lock becomes activated and the
dialog box prompting you to enter the password
appears when you turn on the display unit next
time.
Security authentication
Enter the password that is set for the display unit
when the dialog box prompting you to enter the
password appears.
If you enter the wrong password three times, you
cannot operate the display unit any further. In this
situation, press the 1POWER switch to turn off the
display unit.
To deactivate the Security Lock
Press MENU and set “Security Lock” to “Off” in the
INITIAL SETUP/INFORMATION menu.
INITIAL SETUP/INFORMATION
Language:
Color System:
Auto Shut Off:
Security Lock:
Information
All Reset
Security Lock enabled!
English
Auto
Off
On
Set ENTER Exit MENU Select
Setting an IP address and
communication speed
When an optional adaptor with communication
function such as BKM-FW32 or BKM-FW50 is
installed into the OPTION1 slot in the display unit, set
an IP address and communication speed to control the
display unit via the network.
Note
Setting of an IP address and a communication speed is
completed by selecting “Execute” and pressing ENTER.
When the setting is completed properly, “Done” will
be displayed.
When the setting is not completed properly, an error
code will be displayed. In such a situation, confirm
the setting values and set up again.
Obtaining an IP address
automatically (DHCP)
1
Press MENU.
The main menu appears on the screen.
PICTURE/SOUND CONTROL
Picture Mode:
Adjust Picture
Adjust Sound
Vivid
Set ENTER Exit MENU Select
2
Select “INITIAL SETUP/INFORMATION” with
M/m and press ENTER.
The INITIAL SETUP/INFORMATION menu
appears on the screen.
INITIAL SETUP/INFORMATION
Language:
Color System:
Auto Shut Off:
Security Lock:
Information
All Reset
IP Address Setup
Speed Setup
English
Auto
Off
Off
Set ENTER Exit MENU Select