AEG LAVAMAT L 1045 E - Manual (Page 33)

33
Something not working?
Problem
The door will not open
Possible cause
The programme is still Wait until the end of the
running and the drum programme before opening
is turning. the door.
The water level is above the Before opening the door,
bottom edge of the door. the water must be emptied
out.
The machine is heating the Wait until the end of the
water.
heating phase.
Solution
The machine vibrates or is
noisy
The transit bolts have Check that the machine
not been removed. has been unpacked as
described in the Installation
section.
The feet have not been Carefully level the machine.
adjusted.
There is little laundry in Correct operation of the
the drum. machine is not affected.
Spinning starts late or the
machine does not spin
The unbalance detection If the laundry is not evenly
device that prevents distributed inside the drum
excessive vibration during at the beginning of the
spinning has cut in. spin cycle, the machine
detects this and tries to
redistribute it more evenly
by means of a few drum
rotations.
Only when the laundry is
more evenly distributed
will the spin cycle be
performed, at a lower speed,
if the laundry is not evenly
distributed.
If, after about 10 minutes,
the laundry is still tangled,
the machine will not spin.
Therefore, if the laundry is
still wet at the end of the
cycle, it is advisable to
redistribute it manually
inside the drum and to
select the spin programme.
132996650.qxd 26/09/01 14.30 Pagina 33 (Nero/Process Black pellicola)