Audiovox XMCommander XM-RVR-FM-001C - Manual (Page 7)

Tune to a channel using Tuning Wheel
Tune up and down the channel list by turning the
tuning wheel .
Turn the tuning wheel one increment or
decrement to progress through a list of channels.
Continue to turn the wheel to scroll through the list
and display a new channel with each increment. To
select a channel, press .
Select a channel by remote control
When in DIRECT entry mode the up/down arrow
buttons on the remote control can be used
to move up or down the channel list one channel at
a time. When in PRESET mode they can be used to
move up or down the preset channels in the
current bank. Each new channel will be displayed
for your preview without leaving your current
selection.
1. To display a new channel using the up/down
arrow buttons, press buttons.
2. To select a channel, press . If a channel is not
selected within 6 seconds, the unit reverts to the
current selection.
3. For a fast tuning through the channel listing,
hold down the buttons continuously.
Basic Operations
s e c t i o n 3 6
Caution: Set the volume control at a comfortable sound
level—one that can be heard clearly without distortion.
The Electronics Industry Association’s Consumer Electronics
Group suggest that you avoid prolonged exposure to
excessive noise to reduce the risk of hearing damage or loss.
Turning XMCommander On and Off
Press to power the unit on or off. When first
turned on, the receiver will automatically tune in to
the last channel listened to and recall the previous
settings.
Basic Channel Selection
Select a channel by number
1. Verify that XMCommander is in DIRECT entry
mode. DIRECT should appear in the upper right
corner of the display. If A, B or C appears, press
until the display says DIRECT.
2. Enter channel number using the number keys.
Select using presets
Your XMCommander can store up to 30 preset
channels. They are organized into three different
groups, or memory banks (Preset A, Preset B and
Preset C), each with 10 channels corresponding to the
10 number keys.
Select channel presets
Press until an A, B, or C appears in the
upper right corner of the display. Press the number
key corresponding to the desired preset.
Setting channel presets
1. Tune in the channel you want to register as a
preset.
2. Select either Preset A, Preset B or Preset C by
pressing until an A, B, or C appears in the
upper right corner of the display.
3. Press and hold the number key corresponding
to the preset you would like to set. The channel
name and number will highlight and the audio
will mute for 2 seconds to indicate that the
preset is registered.