Audiovox XMCommander XM-RVR-FM-001C - Manual (Page 9)

Jump
Pressing on the remote causes the radio to
revert to the last channel selected immediately
prior to the current selection. A second press of
returns you to the original channel played
prior to initiating the jump process. With this
feature, you can cycle back and forth between
two channels.
Scan
You can scan through channels in one of the
following ways:
Scan presets
When in the PRESET mode (in preset bank A, B or
C), pressing scrolls you through the preset
channels in the active bank only. The unit scans
channels beginning with the next preset higher in
number than the current preset.
Scan Category
When in the CATEGORY SEARCH mode, pressing
scrolls you through the channels in the
current category only, beginning with the next
higher channel than the current channel.
Scan All
When in DIRECT mode, pressing scrolls you
through all channels, beginning with the next
higher channel than the current preset.
Each channel scanned will play audio for 5 seconds
after which the radio tunes to the next channel in
the scanning order. To lock onto a particular
channel, press or within 5 seconds.
Locking onto a channel automatically exits you
from the scan mode. You can also exit the scan
mode without making a selection by pressing any
of the following , or .
XMCommander returns to the mode in which it
operated prior to entering scan mode.
s e c t i o n 4 8
Special Features
TuneSelect™ — New Feature!
TuneSelect is a new XM feature which allows you
to “tag” up to 15 songs you like and have your XM
Radio alert you when any of those songs is playing
on a different channel.
Activating TuneSelect
To activate TuneSelect, press and hold the ENTER
button at anytime during the playing of a
particular song. When TuneSelect is activated, you
will hear a beep and Song Selected will be
displayed on the screen for 2 seconds and then the
unit will revert to the previous screen information.
When one of your designated songs begins playing
on any other channel, your unit will beep and
SONG FOUND and the channel number and song
name will display on the screen. To go to that
song, simply press the ENTER button. If no
action is taken within 8 seconds, your unit will
revert to the previous screen information of the
currently selected channel and TuneSelect will be
de-activated for that song only until the unit is
powered off and powered on for the next listening
session.
Managing TuneSelect Songs
To erase some or all of the songs identified in
memory with TuneSelect, press the DISP/MENU
button and using the tuning wheel, scroll to
the TuneSelect option. Press ENTER to select.
You will have the option to erase all songs or only
selected songs. TuneSelect can accommodate up
to 15 selections. Once 15 songs are selected,
adding new songs will automatically replace the
oldest song in the list.