Sony UDA-1 - Manual (Page 47)

USB DAC AMPLIFIER
UDA-1
Standby mode
If you switch the AUTO STANDBY switch on the rear panel of the USB DAC AMPLIFIER to “ON, ” when
you are not using the USB DAC AMPLIFIER or there is no digital signal input to the USB DAC AMPLIFIER
for 20 minutes, the unit is automatically turned off and enters standby mode to reduce the power
consumption.
Before the USB DAC AMPLIFIER switches to standby mode, the
lamp flashes for 1 minute, and then
the lamp turns off.
Note
If a very short audio signal of only a few seconds duration is input, the sound may not be detected as
an audio input, and the USB DAC AMPLIFIER may switch to standby mode.
Even when no digital audio is input, the USB DAC AMPLIFIER may not switch to standby mode due to
the operation of other devices connected, or due to connection/disconnection of the cables.
Hint
When the USB DAC AMPLIFIER is in standby mode, you can start the USB DAC AMPLIFIER only by
pressing the
button on the remote control or the unit.
Notes on use
4-469-134-11(2)
Copyright 2013 Sony Corporation
Help Guide
How to Use
47