Sony PEG-SJ20 - Manual (Page 121)

Chapter 3 Exchanging and updating data using a HotSync ® operation
121
Advanced HotSync ® operations
5
Connect your CLIÉ handheld to the USB cable and perform a
HotSync operation.
This HotSync operation records the network information about your
computer onto your CLIÉ handheld.
6
Check if your computer‘s network information (Primary PC
name and Primary PC address) is entered in your CLIÉ
handheld:
1 Rotate the Jog Dial navigator to select HotSync and press the Jog
Dial navigator. Or tap the HotSync
icon on the Application
Launcher screen.
The HotSync screen appears.
2 Tap the Menu icon.
3 Tap Primary PC Setup from the Options menu.
The Primary PC Setup screen is displayed.
4 On your computer, click the HotSync icon in the Windows task
tray and select Setup from the shortcut menu.
5 Click the Network tab, then click TCP/IP Settings to open the TCP/
IP Settings screen.
6 Confirm that the Primary PC name and Primary PC address on both
screens displayed in sub-steps 3 and 5 match. If they do not
match, change the Primary PC name and Primary PC address
entered in your CLIÉ handheld, then tap OK.
7 On your computer, click OK to close the TCP/IP Settings screen and
the Setup screen.
Preparing your CLIÉ handheld and performing a network HotSync
operation
When dialing into a network (Network Modem Sync)
1
Rotate the Jog Dial navigator to select HotSync and press the
Jog Dial navigator. Or tap the HotSync
icon on the
Application Launcher screen.
The HotSync screen appears.
2
Tap the Menu icon.
Continued on next page