AGFA DuoScan f40 - Manual (Page 29)

Chapter 3: Placing Your Originals 29
" Note: If your originals are not properly positioned, you can still adjust the strip by sliding
the closed lid in the required direction.
4 Put the batch slide holder into the batch slide holder frame.
5 Put the batch slide holder frame into the transparency tray of the scanner.
6 x 9 cm and 4 x 5 inch batch slide holders
The 6 x 9 cm batch slide holder and the 4 x 5 inch batch slide holder function in the same way as
the 35 mm batch slide holders.
The 6 x 9 cm and the 4 x 5 inch holders can hold respectively four and two slides at the time. Once
loaded, you put the holder into the transparency tray.
1 Put your original face down in the 6 x 9 cm or 4 x 5 inch batch slide holder.
Figure of 4 x 5 inch batch slide holder
Figure of 6 x 9 cm batch slide holder
2 Put the batch slide holder into the batch slide holder frame.
3 Put the batch slide holder frame into the transparency tray of the scanner.