Sony HDR-CX12 - Manual (Page 16)

16
To remove your camcorder from the
Handycam Station
Turn off the power, then remove the
camcorder from the Handycam Station
holding both your camcorder and the
Handycam Station.
To charge the battery pack using only the AC
Adaptor
Turn off the power, then connect the
AC Adaptor to the DC IN jack on your
camcorder.
Notes

Disconnect the AC Adaptor from the DC IN
jack holding both the camcorder and the DC
plug.

To remove the battery pack
Slide the POWER switch to OFF (CHG).
Slide the BATT (battery) release lever and
remove the battery pack.
Notes

When you remove the battery pack or
disconnect the AC Adaptor, make sure that the
(Movie) lamp/ (Still) lamp (p. 18), access
lamp (p. 25) or the QUICK ON lamp (p. 28) is
turned off.

When you store the battery pack, fully discharge
the battery before storing it for an extended
period (see page 99 for the details of storage).
To use a wall outlet (wall socket) as a power
source
Make the same connections as you do when
charging the battery pack. The battery pack
will not lose its charge in this case.
To check the remaining battery (Battery
Info)
Set the POWER switch to OFF (CHG),
then press DISP/BATT INFO.

POWER switch
DC IN jack
DC plug
Open the
jack cover
With the  mark
on the left
BATT (battery)
release lever