Sony SDM-S95ER - Manual (Page 7)

7
US
5 Hook the stand base holes onto the prongs of stand
to attach. 1
Lift the handle of screw to screw the stand base
securely. 2
Be sure that the screw is secured and turn the screw
handle back.
6 If you use the height adjustable stand, remove the
stopper pin after raising the height adjustable stand
straight.
Note
Do not remove the stopper pin while the stand is laid. It may fall or injure
you by the stand neck coming off the stand base impetuously.
x When using VESA Stand
You can attach a VESA stand in other brands by removing the
supplied stand attached to the display.
Setup 2: Connect the video signal
cables
1 Tilt the display up.
When using the height adjustable stand, raise the
display higher.
1 Stand Base
2 Screw
Stopper Pin
• Turn off the display and computer before connecting.
Notes
• Do not touch the pins of the video signal cable connector as this
might bend the pins.
• Check the alignment of the connector to avoid bending the pins of
the video signal cable connector.
Screws
compatible with
VESA stand (4)