Sony HDR-CX430V - Manual (Page 62)


GB
LCD screen
Do not apply excessive pressure on the LCD
screen, as it may cause uneven color and other
damage.
If your camcorder is used in a cold place, a
residual image may appear on the LCD screen.
This is not a malfunction.
While using your camcorder, the back of
the LCD screen may heat up. This is not a
malfunction.
To clean the casing and the projector
lens (Models with a projector)
Wipe the casing and the lens gently with a
soft cloth such as a cleaning cloth or eyeglass
cleaning cloth.
If the casing and the projector lens is very dirty,
clean the camcorder casing and the lens with
a soft cloth lightly moistened with water, and
then wipe the casing and the projector lens with
a dry soft cloth.
Avoid the following so as not to deform the
casing, damage the finish or scratch the lens:
Using chemicals such as thinner, benzine,
alcohol, chemical cloths, insect repellent,
insecticide and sunscreen
Handling the camcorder with the above
substances on your hands
Leaving the camcorder in contact with rubber
or vinyl objects for a long period of time
About care and storage of the lens
Wipe the surface of the lens clean with a soft
cloth in the following instances:
When there are fingerprints on the lens
surface
In hot or humid locations
When the lens is exposed to salty air such as
at the seaside
Store in a well-ventilated location subject to
little dirt or dust.
To prevent mold, periodically clean and store
the lens as described above.















On charging the pre-installed
rechargeable battery
Your camcorder has a pre-installed
rechargeable battery to retain the date,
time, and other settings even when the
LCD screen is closed. The pre-installed
rechargeable battery is always charged
while your camcorder is connected to the
wall outlet (wall socket) via the AC Adaptor
or while the battery pack is attached. The
rechargeable battery will be fully discharged
in about 3 months if you do not use your
camcorder at all. Charge the pre-installed
rechargeable battery before you start using
your camcorder.
However, even if the pre-installed
rechargeable battery is not charged, the
camcorder operation other than date
recording will not be affected.
How to charge the pre-installed
rechargeable battery
Connect your camcorder to a wall outlet
(wall socket) using the supplied AC
Adaptor, and leave it with the LCD screen
closed for more than 24 hours.
Note on disposal/transfer the
ownership of the camcorder (Models
with internal memory)
Even if you delete all movies and still
images, or perform [Format] (p. 51),
data on the internal memory may not be
completely erased. It is recommended that
you select  [Setup]  [ Media
Settings]  [Format]  [Empty] to
prevent the recovery of your data.