Sony RM-AV3000 - Manual (Page 65)

65
To change the program name on
the Mode Display key
After Step 3, hold the Mode Display key
pressed for more than 2 seconds. The
Commander enter the Label Inputting
mode.
Then follow the same procedure as that
for changing the name of the Label key in
Steps 2 - 5 on page 24.
To change the interval between
timer operation steps
See page 40.
Notes
• When using the timer setting on this
Commander, only one setting can be assigned
to one program. If you want to set the timer
to turn on at a programmed time, and to set
the timer to turn off at another time, program
the two settings separately.
• If there are some programs set to be executed
at the same time, they start in order from the
lowest program number.
• According to the status of the component
operated by the timer program, the next
program might not function successfully.
When setting a timer program, check
carefully the setting of other programs.
Changing the program
already set or changing
another program that you
select
1
Follow Steps 1 - 3 on page 61, 62.
2
Press the COPY key.
If you want to change the program
already set, go to Step 6 without
pressing the COPY key.
The program number appears on the
left Label key, and “COPY” flashes on
the right Label key.
3
Press the COPY key repeatedly
until the program number of
which contents you want to
change appears. (Each time the
COPY key is pressed, the
program number which has the
timer setting information appears
in order.)
Continued