Sony SDM-X202 - Manual (Page 10)

10
If no picture appears on your screen
• Check that the power cord and the video signal cable are
properly connected.
• If “No input signal” appears on the screen:
– Check that the input priority setting is correct (page 16).
– The computer is in the power saving mode. Try pressing any
key on the keyboard or moving the mouse.
– Check that the input signal setting is correct by pressing the
INPUT button (page 11).
• If “Cable disconnected” appears on the screen:
– Check that the video signal cable is properly connected.
– Check that the input signal setting is correct by pressing the
INPUT button (page 11).
• If “Not supported signal” appears on the screen, reconnect the
old monitor. Then adjust the computer’s graphics board within
the following ranges.
For more information about on-screen messages, see “Trouble
symptoms and remedies” on page 21.
No need for specific drivers
The monitor complies with the “DDC” Plug & Play standard and
automatically detects all the monitor’s information. No specific driver
needs to be installed on the computer.
The first time you turn on your computer after connecting the monitor, the
setup Wizard may appear on the screen. In this case, follow the on-screen
instructions. The Plug & Play monitor is automatically selected so that
you can use this monitor.
The vertical frequency is set to 60 Hz.
Since flickers are unobtrusive on the monitor, you can use it as it is. You
do not need to set the vertical frequency to any particular high value.
Setup 7: Adjust the tilt and swivel
This monitor can be adjusted within the angles shown below.
To use the monitor comfortably
Adjust the viewing angle of your monitor according to the height
of your desk and chair, and so that light is not reflected from the
screen to your eyes.
Note
When adjusting the screen tilt and swivel, proceed slowly and carefully,
being sure not to hit the monitor against the desk.
Grasp the sides of the LCD panel, then adjust screen
tilt.
Analog RGB Digital RGB
Horizontal
frequency 28–92 kHz 28–75 kHz
Vertical
frequency 48–85 Hz 60 Hz
Resolution 1600
×
1200 or less 1600
×
1200 or less
approx. 5°
approx. 20°
approx. 45°
approx. 45°