Sony HDR-SR10D User Manual

Page 31

Advertising
background image

31

A

d

d

iti

o

n

a

l In
fo

rm

a

tio

n

US

– Leaving the casing in contact with rubber or

vinyl objects for a long period of time

About care and storage of the lens

• Wipe the surface of the lens clean with a soft

cloth in the following instances:
– When there are fingerprints on the lens

surface.

– In hot or humid locations
– When the lens is exposed to salty air such as

at the seaside.

• Store in a well-ventilated location subject to

little dirt or dust.

• To prevent mold, periodically clean the lens as

described above. It is recommended that you
operate your camcorder about once a month to
keep it in optimum state for a long time.

On charging the pre-installed
rechargeable battery

Your camcorder has a pre-installed
rechargeable battery to retain the date, time,
and other settings even when the POWER
switch is set to OFF (CHG). The pre-
installed rechargeable battery is always
charged while your camcorder is connected
to the wall outlet (wall socket) via the AC
Adaptor or while the battery pack is
attached. The rechargeable battery will be
fully discharged in about 3 months if
you do not use your camcorder at all. Use
your camcorder after charging the pre-
installed rechargeable battery.
However, even if the pre-installed
rechargeable battery is not charged, the
camcorder operation will not be affected as
long as you are not recording the date.

x

Procedures

Connect your camcorder to a wall outlet
(wall socket) using the supplied AC
Adaptor, and leave it with the POWER
switch set to OFF (CHG) for more than 24
hours.

Power supply

You can use your camcorder in any countries/
regions using the AC Adaptor supplied with your
camcorder within the AC 100 V to 240 V, 50/60 Hz
range.
Use a commercially available AC plug adaptor [a],
if necessary, depending on the design of the wall
outlet [b].

To change the battery of the Remote
Commander

1

While pressing on the tab, inset your
fingernail into the slit to pull out the
battery case.

2

Place a new battery with the + side
facing up.

3

Insert the battery case back into the
Remote Commander until it clicks.

• When the lithium battery becomes weak, the

operating distance of the Remote Commander
may shorten, or the Remote Commander may
not function properly. In this case, replace the
battery with a Sony CR2025 lithium battery.
Use of another battery may present a risk of fire
or explosion.

WARNING

Battery may explode if mistreated. Do not
recharge, disassemble or dispose of in
fire.

AC-L200/L200B

[a]

[b]

Tab

Advertising
This manual is related to the following products: