Sony DCR-PC330 - Manual (Page 98)

Dubbing/Editing 98
you have recorded afterwards is not output from the
speaker. Check the sound by using the headphones
or a TV.
Recording sound
1
Insert a recorded cassette into your
camcorder.
2
Slide the POWER switch repeatedly to
select the PLAY/EDIT mode.
3
Touch (play/pause) to play the
tape.
4
Touch (play/pause) again at the
point where you want to start
recording the sound.
The playback pauses.
5
Touch .
6
Touch [AUD DUB CTRL].
If the item is not displayed on the screen,
touch
/ . If you cannot find it, touch
[MENU], and select it from the
(EDIT/PLAY) menu.
7
Touch [AUDIO DUB].
A green X mark appears on the LCD
screen.
8
Touch (play/pause) and start
playing back the audio you want to
record at the same time.
A green mark remains on the LCD
screen while recording sound.
The new sound is recorded in stereo 2 (ST2)
during the playback of the tape.
9
Touch (stop) when you want to
stop recording.
To dub on other scenes, repeat steps 3 and 4
to select scenes, then touch [AUDIO DUB].
10
Touch , then .
To set the end point for audio dubbing
During playback, press ZERO SET MEMORY
on the Remote Commander at the scene at
which you want to stop audio dubbing. Then,
perform steps 4 to 8. The recording stops
automatically at the selected scene.
b Note
• You can only record additional audio over a tape
recorded on your camcorder. The sound may
deteriorate when you dub audio on a tape recorded
on other camcorders (including other DCR-PC330
camcorders).