AT&T 9320 - Manual (Page 4)

Charging the Handset Battery Pack
This battery should remain charged up to six days with the
ringer turned on and up to 12 days with the ringer off. A
fully charged battery provides an average talk time of about
six hours.
The battery pack needs charging when:
•
A new battery is installed in the handset.
• The phone beeps twice when you press
P.
• The phone light flashes slowly.
Place the handset in the base so the CHARGING light
turns on. The battery pack is typically fully charged in
eight hours.
You can keep the battery fully charged by returning the
handset to the base after each use.
If you repeatedly get a low battery indicator, even after
eight hours of charging, the battery should be replaced.
Use only AT&T battery 3301 (SKU# 91076).
CAUTION: Charge the battery provided with or
identified for use with this product only in
accordance with the instructions and limitations
specified in the User’s Manual, Part 1.
Replacing the Handset Battery Pack
1 Remove the battery compartment cover on the
handset by pressing on the indentation and sliding the
cover downward.
2 Lift out the old battery pack and disconnect.
3 Plug battery pack connector into handset. Place the
battery pack and wires in the compartment.
4 Replace the cover by sliding it up into place.
5 The new battery pack must be charged before
using the phone. Place the handset in the base and
allow it to charge for at least 24 hours the first charge.
The telephone might operate before that, but for best
performance, let the battery pack charge fully.
3
B A T T E R I E S
I N S T A L L A T I O N
Attach the belt clip to the cordless handset (optional).
Belt Clip Installation
To attach To remove