Sony PFM-510A1WU - Manual (Page 17)

17
(GB)
PIC SIZE menu
This menu is used for positioning and resizing the
picture.
P I C S I Z E
H S I Z E : 0 0
H S H I F T : 0 0
V S I Z E : 0 0
V S H I F T : 0 0
A S P E C T : 4 x 3
R E S E T
S E L E C T C A N C E L ENTER MENU
0
9
8
7
qa
qs
7 H SIZE
Adjusts the horizontal picture size. Press
M to enlarge
the horizontal size and press m to diminish it.
8 H SHIFT
Adjusts the horizontal centering. Press
M to move the
picture to the right and press m to move it to the left.
9 V SIZE
Adjusts the vertical picture size. Press
M to enlarge
the vertical size and press m to diminish it.
q; V SHIFT
Adjusts the vertical centering. Press
M to move the
picture up and press m to move it down.
qa ASPECT
Set the aspect ratio of the picture to 4:3 or 16:9.
qs RESET
Select to restore the factory settings in the PIC SIZE
menu items 7 to qa.
For details on using the reset function, see “Restoring the
Original Picture Size and Position” on page 24 (GB).
Note
When receiving DTV signals and changing the H/V
SIZE or H/V SHIFT in the PIC SIZE menu, the
system goes into the Offset Sampling Mode; the
image may become blurred or horizontal lines may
appear because the memory write phase is faster than
the read phase. This is not a system malfunction.
To avoid this problem, reset the H/V SIZE and the H/
V SHIFT to the factory settings. If any problems
persist with the factory setting, adjust the settings as
shown below.
To adjust the setting, see “Restoring the original
Picture Size and Position” (page 24 (GB)).
• DTV signals for factory setting:
1080/60i, 480/60i, 575/50i, 480/60p
• Other DTV signals and their recommended settings:
H V H V
ASPECT
SIZE SIZE SHIFT SHIFT
1080/50i + 48 + 11 + 10 – 02 16:9
1080/48i MAX + 09 + 12 – 02 16:9
1152/50i + 33 – 02 + 20 0 16:9
CONFIG menu
This menu is used for adjusting the signal or selecting
the language.
C O N F I G
E N H A N C E : H I G H
H F I L T E R : A U T O
D I S P L A Y : O N
L A N G U A G E
S E L E C T C A N C E L ENTER MENU
qg
qf
qd
qh
qd ENHANCE (Sharpness)
You can change the outline correction level:
LOW: Default setting for VIDEO signal
HIGH: Default setting for computer signal
qf H FILTER
Select AUTO normally.
Select HIGH when the ringing appears on the screen.
Select LOW when the moiré pattern or noise appears
on the screen. The moiré pattern or noise decreases
even the screen looks a little blurred.
qg DISPLAY
Select ON to display the input signal information for
about five seconds on the top of the monitor screen
when turning on the power or switching the input
signal.
qh LANGUAGE
Select the on-screen language among five languages.
Available languages are: English, German, French,
Italian and Spanish.
For details on selecting the language, see “Selecting the
On-screen Language” on page 26 (GB).
Using On-screen Menus