Sony HDR-PJ650V - Manual (Page 63)


GB
O
thers/I
nde
x
On handling the LCD screen
If you leave fingerprints, hand cream, etc. on
the LCD screen, the coating of the LCD screen
will come off easily. Wipe those off as soon as
possible.
If you wipe the LCD screen strongly with a
tissue, etc., the coating of the LCD screen may
be scratched.
If the LCD screen becomes dirty with
fingerprints or dust, it is recommended that you
gently remove those from the screen then clean
it with a soft cloth, etc.
LCD screen
Do not apply excessive pressure on the LCD
screen, as it may cause uneven color and other
damage.
If your camcorder is used in a cold place, a
residual image may appear on the LCD screen.
This is not a malfunction.
While using your camcorder, the back of
the LCD screen may heat up. This is not a
malfunction.
To clean the casing and the projector
lens
Wipe the casing and the lens gently with a
soft cloth such as a cleaning cloth or eyeglass
cleaning cloth.
If the casing and the projector lens is very dirty,
clean the camcorder casing and the lens with
a soft cloth lightly moistened with water, and
then wipe the casing and the projector lens with
a dry soft cloth.
Avoid the following so as not to deform the
casing, damage the finish or scratch the lens:
Using chemicals such as thinner, benzine,
alcohol, chemical cloths, insect repellent,
insecticide and sunscreen
Handling the camcorder with the above
substances on your hands











Leaving the camcorder in contact with rubber
or vinyl objects for a long period of time
On handling the light-emitting part
of flash
If the LCD screen becomes dirty with
fingerprints or dust, it is recommended that
you use a soft cloth to clean it.
About care and storage of the lens
Wipe the surface of the lens clean with a soft
cloth in the following instances:
When there are fingerprints on the lens
surface
In hot or humid locations
When the lens is exposed to salty air such as
at the seaside
Store in a well-ventilated location subject to
little dirt or dust.
To prevent mold, periodically clean and store
the lens as described above.
On charging the pre-installed
rechargeable battery
Your camcorder has a pre-installed
rechargeable battery to retain the date,
time, and other settings even when the
LCD screen is closed. The pre-installed
rechargeable battery is always charged
while your camcorder is connected to the
wall outlet (wall socket) via the AC Adaptor
or while the battery pack is attached. The
rechargeable battery will be fully discharged
in about 3 months if you do not use your
camcorder at all. Charge the pre-installed
rechargeable battery before you start using
your camcorder.






