Sony STR-DE875 - Manual (Page 13)

13
Hooking Up the Components
AUDIO
OUT
OUT IN
S-LINK
VIDEO
IN
IN
S-LINK
VIDEO
OUT
AUDIO
OUT
OUTPUT
IN
S-LINK
VIDEO
OUT
AUDIO
OUT
OUTPUT
AUDIO IN AUDIO IN AUDIO OUT AUDIO IN
VIDEO OUT VIDEO IN VIDEO IN VIDEO IN VIDEO OUT
S-VIDEO OUT S-VIDEO OUT S-VIDEO IN S-VIDEO IN S-VIDEO IN CTRL S IN CTRL S OUT CTRL S OUT CTRL S STATUS IN
MONITOR
TV/SAT DVD/LD VIDEO 1
R
L
R
L
*
*
* * **
A
D E
B
C
TV
Receiver
S-LINK CONTROL S hookup
If you have a S-LINK CONTROL S-compatible Sony TV,
satellite tuner, monitor, DVD player or VCR, use an
audio/video/control S connecting cord (supplied) or a
control S connecting cord (supplied) to connect the CTRL
S (STATUS) IN (for TV, satellite tuner, or monitor) or OUT
(for VCR, etc.) jack on the receiver to the appropriate S-
LINK jack on the respective component. Refer to the
operating instructions supplied with your TV, satellite
tuner, monitor, VCR, etc., for details.
The following illustration is an example of S-LINK
CONTROL S hookups between the receiver, a TV, a VCR,
and a DVD player. When your TV is connected to the
receiver as shown below, the TV input mode will change
to video input whenever you turn on the receiver. When
you connect the receiver as shown below, input mode of
the receiver changes to VIDEO 1 or DVD/LD whenever
you play your VCR or DVD.
The following connections also change the input mode of
the receiver to TV whenever you operate your TV.
VCR 1
DVD
player
CONTROL A1 hookup
• If you have a CONTROL A1 compatible Sony
CD player, SACD player, tape deck, or MD deck
Use a CONTROL A1 cord (not supplied) to connect the
CONTROL A1 jack on the CD player, SACD player,
tape deck, or MD deck to the CONTROL A1 jack on
the receiver. Refer “CONTROL-A1 Control System”
on page 53 and the operating instructions supplied with
your CD player, SACD player, tape deck, or MD deck
for details.
Note
If you make CONTROL A1 connections from the receiver to
an MD deck that is also connected to a computer, do not
operate the receiver while using the “Sony MD Editor”
software. This may cause a malfunction.
• If you have a Sony CD changer with a
COMMAND MODE selector
If your CD changer’s COMMAND MODE selector can
be set to CD 1, CD 2, or CD 3, be sure to set the
command mode to “CD 1” and connect the changer to
the CD jacks on the receiver.
If, however, you have a Sony CD changer with VIDEO
OUT jacks, set the command mode to “CD 2” and
connect the changer to the VIDEO 2 jacks on the
receiver.