Message lists, Warning messages message lists – Sony VPL-VW200 User Manual
Page 63
63
Ot
hers
Warning messages
Message Lists
Message
Cause and Remedy
High temp.! Lamp off in 1
min.
c Turn off the power.
c Check to ensure that nothing is blocking the ventilation holes.
Frequency is out of range!
c Frequency is out of range. Input a signal that is within the
acceptable frequency range of the projector.
Please check Input-A
Signal Sel.
c Set “Input-A Signal Sel.” in the Setup
menu to
“Computer” when an RGB signal is input from a computer.
(
Please replace the Lamp/
Filter.
Lamp/Filter life remains
less than 50H.
c The remaining available usage time for the lamp and the air
filter is short. (Estimated approximately 50 hours.)
To clear the message on the screen, press any key on the remote
control or the control panel of the projector once.
Please replace the Lamp/
Filter.
Lamp/Filter life remains
less than 15H.
c The remaining available usage time for the lamp and the air
filter is short. (Estimated approximately 15 hours.)
To clear the message on the screen, press any key on the remote
control or the control panel of the projector once.
Please replace the Lamp/
Filter.
End of Lamp/Filter life.
Lamp off in 1 min.
c It is time to replace the lamp. Replace the lamp. (1 page 65)
c Also, replace the air filter too. (1 page 65)
If the message appears again after you replace the lamp and the
air filter, the lamp replacement process is not complete. Check
the lamp replacement process. (
Please clean the filter.
c It is time to clean the air filter. Clean the air filter. (1 page 70)
To clear the message on the screen, press any key on the remote
control or the control panel of the projector once.
Please clean the filter. Have
you finished? Yes No
c It is time to clean the air filter. Clean the air filter. (1 page 70)
c If you cleaned the air filter, select “Yes.” If you did not clean the
air filter, select “No.”
Projector temperature is
high. Cooling Setting
should be “High” if
projector is being used at
high altitude.
c Check to ensure that the Ventilation holes on the unit are not
covered. (
c When using the projector at high altitude, set the Cooling
Setting to “High”. (
When temperature inside the projector remains high, the Cooling
Setting is switched to “High” in one minute, then the fan speed
increases.
Note
Note
Note
Note