Operation, Maintenance – Agri-Fab 45-03371 User Manual
Page 12
12
HOW TO USE YOUR SWEEPER
BRUSH HEIGHT ADJUSTmENT
To adjust your sweeper brushes to the best operating
height, loosen the adjustment knob and push down
on the height adjustment lever to raise the brush. Best
adjustment is when the brush setting is 1/2" down into
the grass. Always mow the grass to an even height
before sweeping.
SWEEPING SPEED
Try a starting speed of approximately 3 m.p.h. (third gear
on most tractors). Depending on the conditions, it may
be necessary to adjust the sweeping speed in order to
achieve best results.
DUmPING OF SWEEPER
Your sweeper can be dumped easily without getting
off of the rider or tractor. Simply pull the rope forward
to dump the hopper. Always empty hopper after each
use.
CAUTION: Keep sweeper away from fire.
Excessive heat can damage the brushes and
hopper bag and could cause the bag and its
contents to burn.
CAUTION: Never attach the hopper rope to any
part of your body or clothing!
Never hold onto
the rope while towing the sweeper!
Attach the
rope to the towing vehicle to keep it away from
wheels and rotating parts.
OPERATION
CUSTOmER RESPONSIBILITIES
1.
Check for loose fasteners before each use.
2.
Clean the sweeper after each use.
a. Clean sweeper housing with a soft brush or cloth.
b. Clean debris from hopper bag with a brush or
broom.
c. Remove any material which has wrapped around
brushes or ends of brush shaft.
3. Inspect for worn or damaged parts, such as brushes
and wheels before each use. Replace as necessary.
mAINTENANCE
24
ENGLISH
LUBRICATE WHEEL BEARINGS
5.
(Figure 25) Lubricate the wheel bearings once every
season with a few drops of light weight oil.
CLEAN/LUBRICATE WHEEL GEARS
6.
(Figure 26) Every two years remove the wheels and
clean the gears found inside the wheel housing. After
cleaning, lubricate with an even coat of light grease.
25
26
4.
(Figure 24) Lubricate the brush shaft bearing twice a
year with a few drops of light weight oil.
HEIGHT ADJUSTMENT SLOT
HEX BOLT
OIL BEARINGS HERE
FLAT WASHER
GEAR
AXLE
FLAT WASHER
"E" RING
HUB CAP