Agri-Fab 45-03371 - Manual (Page 7)

7
12. (Figure 9) Position the height adjustment handle side to
side so that the tooth lock washer (M) can fit between
the handle and the height adjustment strap.
Tighten
the nuts securing the height adjustment handle.
13. (Figure 9) Insert the 5/16" x 1" carriage bolt (E) through
the height adjustment handle. Assemble onto the bolt,
in order, the 5/16" tooth-lock washer (M), the height
adjustment strap, a 5/16" flat washer (J) and the plastic
knob.
2. (Figure 11) Insert the two upper hopper side tubes
through the stitched flaps on each side of the hopper
bag.
3. (Figure 11) Assemble the ends of the rear hopper tube
onto the ends of the upper hopper side tubes. Fasten
together using plastic plugs (Z).
9
11
ENGLISH
11. (Figure 8) Insert a 5/16" x 3/4" hex bolt (F) through the
angle bracket. Assemble onto the bolt (in order) the
spacer bushing (T), the height adjustment strap, a 5/16"
flat washer (J) and a 5/16" nylock nut (G).
Tighten.
8
ASSEmBLY OF HOPPER BAG
1. (Figure 10) Turn a rear hopper tube so that the brace
holes in the middle of the tube face down.
10
5/16" NYLOCK
NUT (G)
5/16" FLAT
WASHER (J)
HEIGHT
ADJUSTMENT
STRAP
5/16" x 3/4"
HEX BOLT (F)
SPACER
BUSHING (T)
5/16" x 1"
CARRIAGE BOLT (E)
TOOTH LOCK
WASHER (M)
PLASTIC
KNOB
5/16" FLAT
WASHER (J)
REAR HOPPER TUBE
(brace holes on bottom)
UPPER HOPPER
SIDE TUBE
PLASTIC PLUG (Z)