Sony LF-X11 - Manual (Page 6)

Gettin
g
Star
ted
6
Notes
• Depending on the condition of the Base Station
and the PSP™ system, it may take a few
minutes to complete the settings.
• If more than 5 minutes pass from when the
SETUP MODE LED started to blink, the LED
will go from blinking to fully lit and the Base
Station will no longer register the PSP™
system.
In this case, press the SETUP MODE button on
the Base Station rear again and hold the button
down until the SETUP MODE LED starts to
blink.
• If a message stating "You must update the base
station" is displayed, you must perform a
software version update. You can perform the
update from the Base Station Settings menu
(
1 page 28).
5
Check the settings list.
Press the
button to finish the settings. A
network settings list is displayed.
Note
If a message stating "The wireless channel of the
base station is set to the 5 GHz range" is
displayed, you must change the settings for the
Base Station.
For details, refer to the Operating Instructions
document supplied with the Base Station.
6
Connect to the Base Station.
Select [LocationFree AP], and then press the
button.
A connection to the Base Station is
established.
7
The TV screen is displayed.
When a connection to the Base Station is
established, the TV screen will be displayed.
For detailed usage instructions, refer to
"Watching TV or Videos on the
LocationFree Player" (
1 page 7).
You can close the LocationFree Player by
pressing the
button.
Go to page 17 and set the TV channels.
To watch TV or videos away from home, proceed
to "Using "Easy Setup" to Watch TV or Videos
Away From Home" (
1 page 14).