AltiGen comm 720 - Manual (Page 23)

IP 720 User Manual 15
c. The phone will attempt to register, as shown in the LCD screen:
If the phone successfully passes through these stages, the phone
shows the date, time, and extension in the LCD screen and is now in
normal operating mode.
If it doesn’t pass through these stages successfully, refer to
“Troubleshooting” on page 34.
Miscellaneous Operation Notes
• Logging in and out—When using #26 and #27 to log out / log in, the
IP 720 must be onhook. Pressing the Speaker button and then using
#26 or #27 will not work.
• BASIC mode—If the IP 720 phone fails to register with MAXCS
during startup, the phone operates in Basic mode. When in Basic
mode, the IP phone’s LCD display shows (BASIC) IDLE.
No MAXCS switching features are available in this operating mode.
However, the phone user can enter a destination IP address followed
by #, and make an outgoing call through the IP network to reach
MAXCS or another IP 720 phone. Also, the IP phone can accept
incoming calls originating from MAXCS or another IP 720 phone.
If the IP phone’s local configuration is changed while in BASIC
mode, the changes are overridden by MaxAdministrator settings.
• Incoming call takes priority—If a call comes in while you are using
any phone menu or display (such as workgroup display or Call Log),
the phone will exit the menu and go to the ring state.
• Restoring default settings—To automatically restore the original
default settings for the IP 720 phone:
1. Press the Menu button.
2. Press * * 2, then press the Enter button.
REGISTERING...
01/12 04:16PM x300