Sony DSX-S300BTX - Manual (Page 35)

35
Notes
• Check that unit and cellular phone are connected
beforehand.
• Store a voice tag on your cellular phone beforehand.
• If you activate voice dialing with a cellular phone
connected to this unit, this function may not work in
some cases.
• Noises such as the engine running may interfere
with sound recognition. In order to improve
recognition, operate under conditions where noise is
minimized.
• Voice dialing may not work in some situations,
depending on the effectiveness of the cellular
phone’s recognition function. For details, see the
support site.
• Do not use voice dialing on the cellular phone during
handsfree device connection.
Tips
• Speak in the same way as you did when you stored
the voice tag.
• Store a voice tag while seated in the car, via this unit
with Bluetooth Phone source selected.
SMS indicator
While connecting a cellular phone to this unit,
the SMS indicator informs you of any incoming
or unread SMS messages.
If you receive a new SMS message, the SMS
indicator flashes.
If there are any unread SMS messages, the SMS
indicator stays lit.
Note
Function of the SMS indicator may depend on the
cellular phone.
Music streaming
Listening to music from an audio
device
You can listen to music of an audio device on this
unit if the audio device supports A2DP
(Advanced Audio Distribution Profile) of
Bluetooth technology.
1
Connect this unit and the Bluetooth
audio device (page 32).
“
” appears during connection.
2
Turn down the volume on this unit.
3
Press (SOURCE/OFF) repeatedly until
“Bluetooth Audio” appears.
4
Operate the audio device to start
playback.
5
Adjust the volume on this unit.
Adjusting the volume level
The volume level is adjustable for any difference
between the unit and the Bluetooth audio device.
1 Start playback of the Bluetooth audio device at
a moderate volume.
2 Set your usual listening volume on the unit.
3 Press the multi way encoder.
4 Rotate the multi way encoder until “Bluetooth
Audio Level” appears, then press it.
5 Rotate the multi way encoder to adjust the
input level (“+ 18dB” – “0dB” – “– 8dB”).