Sony DSX-S300BTX - Manual (Page 39)

39
5
Press (BACK).
The display returns to normal reception/play
mode.
To cancel listening position, select “off” on step
3.
Note
If you select “Custom” in step 3 above, you cannot set
the subwoofer position.
Precisely calibrating by Time
Alignment
— Listening Position Custom Tune
You can precisely calibrate your listening
position from each speaker so that the sound
delay reaches the listener more correctly.
Before starting, measure the distance between
your listening position and each speaker.
Select “Custom” of Listening Position Front/
Rear.
1
During reception/playback, press the
multi way encoder.
2
Rotate the multi way encoder until
“Listening Position Custom Tune”
appears, then press it.
3
Setting for the listening position.
• Speaker Select
Push the multi way encoder left/right to select
the speaker.
• Distance
Push the multi way encoder up/down to set the
distance between your listening position and
speakers.
The distance is adjustable in 2 cm (
4 /
5
in) steps,
between 30 and 300 cm (0.99 and 9.9 ft).
4
Press the multi way encoder when you
complete all settings.
5
Press (BACK).
The display returns to normal reception/play
mode.
DM+ Advanced
DM+ Advanced improves digitally compressed
sound by restoring high frequencies lost in the
compression process.
This function works when the USB, SensMe™
or Bluetooth Audio source is selected only.
1
During playback, press the multi way
encoder.
2
Rotate the multi way encoder until
“DM+ Advanced” appears, then press
it.
3
Push the multi way encoder up/down
to select “on,” then press it.
4
Press (BACK).
The display returns to normal reception/play
mode.
Tip
Adjusted DM+ settings can be memorized separately
for USB (SensMe™) and Bluetooth Audio sources.
Using rear speakers as subwoofer
— Rear Bass Enhancer
Rear Bass Enhancer enhances the bass sound by
applying the low pass filter setting (page 37) to
the rear speakers. This function allows the rear
speakers to work as a subwoofer if one is not
connected.
1
During reception/playback, press the
multi way encoder.
2
Rotate the multi way encoder until
“Rear Bass Enhancer” appears, then
press it.
3
Push the multi way encoder up/down
to select from “Level 1,” “Level 2” or
“Level 3,” then press it.
4
Press (BACK).
The display returns to normal reception/play
mode.