Sony STR-DH820 User Manual
Page 81
81
GB
D:\SONY job\STR-DH820_PMRF_02\GB\4266497121\GB06REM_STR-DH820-CEL.fm
masterpage: Right
STR-DH820
4-266-497-11(2)
Using the Rem
o
te Contr
o
l
3
Press the numeric buttons to
enter the numeric code.
If more than one code exists, try to enter
either one which corresponds to the
equipment including TV.
Use the tables on page 81–84 to find the
numeric code(s) corresponding to the
equipment.
Note
Only the codes in the 500’s are valid for the TV
button.
4
Press ENT/MEM.
Once the numeric code has been verified,
the RM SET UP indicator slowly flashes
twice and the remote control
automatically exits the programming
mode.
5
Repeat steps 1 to 4 to program
other equipment.
Note
The RM SET UP indicator turns off while a numeric
button is pressed.
To cancel programming
Press RM SET UP during any step. The
remote control automatically exits the
programming mode.
To activate the input after
programming
Press the programmed button to activate the
input you want.
If programming is
unsuccessful, check the
following:
• If the RM SET UP indicator does not light
up in step 1, the batteries are weak. Replace
both batteries.
• If the RM SET UP indicator flashes 5 times
in quick succession while entering the
numeric code, an error has occurred.
Start again from step 1.
Use the numeric codes in the tables below to
program non-Sony equipment and also Sony
equipment that the remote control is normally
unable to control. Since the signal from the
remote control received by the equipment
differs by its model and the year, more than
one numeric code may be assigned to the
equipment. If you fail to program your remote
control using one of the codes, try using other
codes.
Notes
• The numeric codes are based on the latest
information available for each brand. There is a
chance, however, that your equipment will not
respond to some or all of the codes.
• All of the input buttons on this remote control may
not be available when used with your particular
equipment.
To control a CD player
To control a DAT deck
The numeric codes
corresponding to the equipment
and the maker of the equipment
Maker
Code(s)
SONY
101, 102, 103
DENON
104, 123
JVC
105, 106, 107
KENWOOD
108, 109, 110
MAGNAVOX
111, 116
MARANTZ
116
ONKYO
112, 113, 114
PANASONIC
115
PHILIPS
116
PIONEER
117
TECHNICS
115, 118, 119
YAMAHA
120, 121, 122
Maker
Code(s)
SONY
203
PIONEER
219
continued