Sony ILCE-7S - Manual (Page 194)

2. Press the WPS button on the access point you want to register.
Note
[WPS Push] works only if the security setting of your access point is set to WPA or WPA2
and your access point supports the WPS button method. If the security setting is set to
WEP or your access point does not support the WPS button method, perform [Access
Point Set.].
For details about the available functions and settings of your access point, see the access
point operating instructions or contact the administrator of the access point.
A connection may not be enabled depending on the surrounding conditions, such as the
type of wall material or if there is an obstruction or poor wireless signal between the
product and access point. If that happens, change the location of the product or move the
product closer to the access point.
[234] How to Use Using Wi-Fi functions Changing the settings of Wi-Fi functions
Access Point Set.
You can register your access point manually. Before starting the procedure, check the SSID
name of the access point, security system, and password. The password may be preset in
some devices. For details, see the access point operating instructions, or consult the access
point administrator.
1. MENU
→
(Wireless
) → [Access Point Set.].
2. Select the access point you want to register.
When the desired access point is displayed on the screen: Select the desired
access point.
When the desired access point is not displayed on the screen: Select [Manual
Setting] and set the access point.
*
For the input method, refer to “How to use the keyboard.”
If you select [Manual Setting], input the SSID name of the access point, then select
the security system.