Sony PCG-FX290K - Manual (Page 77)

Connecting an i.LINK® Device
77
To connect a USB device
❑ Locate the USB device identified by the symbol. Plug one end of the USB
cable into this port and the other end into the USB device.
You can use an optional Sony USB mouse PCGA-UMS1 series (not supplied)
with this computer. Since the USB mouse software driver is preinstalled in the
computer, you simply plug the USB mouse into the USB connector to use it. One
USB connector supports one USB device.
Connecting an i.LINK
*
® Device
You can connect an i.LINK-enabled digital video camera recorder to
the i.LINK® S400
(IEEE1394) connector.
✍
Before you connect or disconnect a mouse, turn off the computer.
The following steps describe the procedure for connecting a USB mouse to your
computer. Use the same procedure for connecting all USB devices.
Connecting USB device to USB connector
✍
See the manual that came with your USB device for more information on its
installation and use.
* i.LINK is a SONY trademark used to designate that a product contains an IEEE 1394 con-
nector. All products with an i.LINK connector may not communicate with each other.
To
USB device
USB
USB connecting cable
(optional)