AMX DAS-SIRIUS - Manual (Page 12)

DAS-SIRIUS Tuner Module
8 DAS-SIRIUS Sirius Satellite Radio Tuner Module
Connecting and Positioning the SIRIUS Antenna
1. Connect the provided SIRIUS Antenna to the DAS-SIRIUS (see FIG. 1).
2. Verify the Signal strength
a. Via the programming menus via the front of the Controller, select Setup\SIRIUS.
b. Select Status. In this menu, you can check the following:
c. Select "SAT" to determine the Satellite Signal Strength (None, Weak or Good).
d. Ensure the signal strength is at a minimum of "weak". Adjustments may need to be made to the
position of the Antenna in order to get a better signal.
Activating Your SIRIUS Subscription
SIRIUS Satellite Radio is a subscription service. In order to use your DAS-SIRIUS module, you will have to
activate your SIRIUS subscription.
1. Once you have installed the DAS-SIRIUS module, you can activate your SIRIUS subscription by phone:
Call 1.888.539.SIRIUS (7474).
2. You will be asked for a “Sirius ID”. This ID can be found in several places:
If using a Matrix LCD keypad, select channel "0" to display the Sirius ID.
If using either a Metreau or Matrix tactile keypad with the optional numeric keypad, select channel
"0". The Sirius ID will be displayed on the LCD display on the front of the Controller.
If using either a Metreau or Matrix tactile keypad without the optional numeric keypad, access the
programming menus via the front of the Controller by pressing the centre Nav button on the
Controller:
Select Setup\SIRIUS, then select ID from the SIRIUS menu, and the SIRIUS ID will be displayed.
FIG. 14 Audio Controller Jumper Configuration (No TUNER 1)
• ANT: Antenna Status
• ACT: Activation Status
• SAT: Satellite Signal
• TER: Terrestrial Signal
Tuner 2 jumpers (in OFF position)
3
1
3
1
TUNER 2
Jumpers
Top Left of Rear-Board Pin Bus
Until you have activated your subscription, you will only be able to tune to channels
0 and 184.