Sony RM-TP2 - Manual (Page 19)

19 GB
Operations for Sony Amplifiers/Receivers / 2 Way Remote Operations
When using Sony amplifiers/receivers, you can
operate various functions. Before operating,
register the Sony amplifier/receiver (page 10).
When selecting Sony amplifier/receiver from
the IR SETUP: MAKER CODE list, be sure to
select the appropriate command mode.
About the command mode (IR type)
If the amplifier/receiver’s command mode (IR type)
and the commander’s command mode (IR type) do
not match, you cannot use the commander to operate
the amplifier/receiver.
Tip
To use the multi room function of the amplifier/
receiver, select SONY MULTI ROOM1 (or 2) from
the IR SETUP: MAKER CODE list. The multi room
functions (2ND ZONE and 3RD ZONE) are initially
registered in the RM SELECT screen (2/2).
Operating the amplifier/
receiver
1
Touch RM SELECT.
The RM SELECT screen appears.
2
Touch AMP.
The screen for operating the amplifier/
receiver appears.
3
Touch B or b to select the screen.
For details on each screen, see below.
Notes
• Depending on the amplifier/receiver, some
commands may not function.
• For details about the operations, refer to the
operating instructions supplied with the amplifier/
receiver.
Screen 1/6
This screen is mainly for switching the input.
Operations for Sony Amplifiers/Receivers
Screen 2/6
This screen is mainly for enjoying surround
sound.
Screen 3/6
This screen is for adjusting the level and
balance and adjusting the volume.
Screen 4/6
This screen is mainly for adjusting the
equalizer and outputting the test tone. You can
also adjust various settings using the MAIN
MENU key, cursor keys, and ENTER key.
When the amplifier/receiver has ON SCREEN
function, it is recommended to adjust the
settings using the TV screen.
Screen 5/6
This screen is mainly for setting the display on
the amplifier/receiver and selecting the audio
input.