Sony KE-42XBR900 - Manual (Page 56)

54
Remote C
ontrol
Programming the Remote Control
The remote control is preset to operate Sony brand video equipment.
If you have video equipment other than Sony brand that you want to control
with the TV’s remote control, use the following procedure to program the
remote control.
The equipment must have infrared (IR) remote capability in
order to be used with the remote control.
1 Turn to the list of “Manufacturer’s Codes” on page 55, and find the
three-digit code number for the manufacturer of your equipment. (If
more than one code number is listed, use the number listed first.)
2 Press FUNCTION repeatedly until the DVD/VCR or SAT/CABLE
indicator lights up.
3 While the desired indicator is lit, enter the three-digit manufacturer’s
code number.
4 Press ENTER .
You must do step 4 within 10 seconds of step 3, or you must
redo steps 3 through 4.
5 To check if the code number works, aim the TV’s remote control at the
equipment and press
POWER that corresponds with that equipment. If
it responds, you are done. If not, try using another code listed for that
manufacturer.
Notes
s If more than one code number is listed, try entering them one by one
until you come to the correct code for your equipment.
s If you enter a new code number, the code number you previously
entered at that setting is erased.
s In some cases, you may not be able to operate your equipment with the
supplied remote control. In such cases, use the equipment’s own remote
control unit.
s Whenever you remove the batteries to replace them, the code numbers
may revert to the factory setting and must be reset.
Sony Equipment Programmable Code Number
Beta, Ed Beta VCRs 303
8 mm VCR 302
VHS VCR 301
DVD player 751