ATEN CS-1762 - Manual (Page 51)

Appendix
43
Monitor does not
display after KVM
cable set is hot
plugged. Some HDMI/DVI
graphics cards are
incompatible with
cable set hot
plugging. Power off all devices on the
installation (see safety note, page 9);
power off the CS1764A; confirm all
KVM cables are properly connected;
power on the CS1764A; power on
the computers
When switching
ports, the monitor
does not display. Monitor is new or
this is the first time
installation. Switch ports again and wait two or
more seconds for the PC’s EDID to
pass to the monitor.
The PC’s EDID has
not passed through
to the monitor when
switching ports Use the [d] hotkey to invoke Video
DynaSync one more time or switch
to another PC to reconnect the
CS1764A. See HSM Summary
Table, page 32.
Symptom Possible Cause Action