ATEN CS-1762 - Manual (Page 43)

6. The Firmware Upgrade Utility
35
Upgrade Succeeded
After the upgrade has completed, a screen appears to inform you that the
procedure was successful:
Click Finish to close the Firmware Upgrade Utility.
After a successful completion, the CS1762
A
/ CS1764
A
exits Firmware
Upgrade Mode, and resets itself.
Upgrade Failed
If the Upgrade Succeeded screen doesn’t appear, it means that the upgrade
failed to complete successfully, in which case you should do the following:
1. Power off the CS1762
A
/ CS1764
A
by removing the power jack.
2. Invoke Firmware Upgrade Mode by holding down the front panel Mode
Selection pushbutton (see Components, page 6) and power on the
CS1762
A
/ CS1764
A
. The orange LEDs flash together.
3. Do the firmware upgrade procedure again.