Sony DSC-TX5 - Manual (Page 131)

Ta
ble
of
co
nte
n
ts
Op
e
rat
io
n
S
ear
ch
MENU/Settin
g
s
Se
ar
ch
In
de
x
131 GB
The remaining charge indicator is incorrect.
• This is caused when you use the camera in an extremely hot or cold location.
• A discrepancy arose between the remaining charge indicator and the actual remaining battery charge.
Fully discharge the battery pack once, then charge it to correct the indication. Depending on
conditions of use, the display may remain incorrect.
• Battery capacity decreases over time and through repeated use. When the operating time per charge
decreases markedly, the battery pack needs to be replaced. Purchase a new battery pack.
Cannot charge the battery pack.
• You cannot charge the battery pack using the AC Adaptor (sold separately). Use the battery charger
to charge the battery.
The CHARGE lamp flashes while charging the battery.
• Remove and reinsert the battery pack, making sure it is installed correctly.
• The temperature may be inappropriate for charging. Try charging the battery pack again within the
proper charging temperature range (10°C to 30°C (50°F to 86°F)).
• For details, see page 145.
Cannot record images.
• When images cannot be recorded into a memory card but are recorded into the internal memory, even
though a memory card has been inserted into the camera, make sure that the memory card has been
fully inserted.
• Check the free capacity of the internal memory or the memory card. If it is full, do one of the
following:
– Delete unnecessary images (page 74).
– Change the memory card.
• You cannot record images while charging the flash.
• When recording movies, it is recommended that you use the following memory cards:
– “Memory Stick PRO Duo” (Mark2) media, “Memory Stick PRO-HG Duo” media
– SD memory card or SDHC memory card (Class 4 or faster)
• Set [Demo Mode] to [Off] (page 98).
Smile Shutter function does not work.
• No image is shot if a smiling face is not detected.
• Set [Demo Mode] to [Off] (page 98).
Anti-blur function does not work.
• The anti-blur function may not work properly when shooting night scenes.
• Shoot after pressing the shutter button halfway down.
Recording takes a long time.
• When the shutter speed becomes slower than a certain speed, for example, when you shoot images in
dark locations, the camera automatically reduces the image noise. This function is called NR (noise
reduction) slow shutter and the shooting time takes longer.
• The Anti Blink function is working. When [Anti Blink] is set to [Auto], reset to [Off] (page 66).
Shooting still images/movies