Sony DVP-NS400D - Manual (Page 73)

S
e
tt
ings
a
nd Adjus
tme
nts
73
•
REAR
* Rear speaker position (REAR/SIDE)
Correctly specify the location of the rear speakers to
enjoy the SURROUND effect.
•
Set to the “SIDE,” if the location of the rear
speakers corresponds to section A below.
•
Set to the “REAR,” if the location of the rear
speakers corresponds to section B below.
This setting affects only “VIRTUAL REAR
SHIFT,” “VIRTUAL MULTI REAR,” and
“VIRTUAL MULTI DIMENSION” mode (page
51).
•
SUBWOOFER
Notes
•
The cut off frequency for the subwoofer is fixed at
120 Hz.
•
If your speakers are too small to reproduce low bass
frequencies, please set all speaker settings to
“SMALL” and utilize a subwoofer for low
frequency sound.
•
Even if there are fewer than 6 speakers connected,
the player distributes the audio signal components to
the front speakers.
x DISTANCE
The default distance setting for the speakers
in relation to the listening position is shown
below.
Be sure to change the value in the Setup
Display when you move the speakers. The
default adjustments are in parentheses.
SMALL When the sound cracks or the
surround sound effects are difficult to
hear, select this. This activates the
Dolby Digital bass redirection
circuitry and outputs the bass
frequencies of the center speaker from
other speakers.
NONE If you do not connect rear speakers,
select this.
LARGE (REAR/SIDE): Normally select this
position. Select either of these
according to the rear speaker’s
position*.
SMALL (REAR/SIDE): When the sound
cracks or the surround sound effects
are difficult to hear, select this.
Select either of these according to the
rear speaker’s position*.
This activates the Dolby Digital bass
redirection circuitry and outputs the
bass frequencies of the rear speaker
from other speakers.
90
20
45
NONE If you do not connect a subwoofer,
select this. This activates the Dolby
Digital bass redirection circuitry and
outputs the LFE signals from the front
speakers as long as the front speaker
size is set to “LARGE.”
YES If you connect a subwoofer, select this
to output the LFE (low frequency
effect) channel from the subwoofer.
When you set the other speakers
settings to “SMALL,” the subwoofer
makes up for the missing bass
frequencies of the speakers.
12ft/3.6m 12ft/3.6m
12ft/3.6m
10ft/3.0m 10ft/3.0m
continued