Sony VPL-EX100 - Manual (Page 28)

GB 8
Checking the Supplied Accessories
Checking the Supplied Accessories
RM-PJ7 Remote Commander (1)
Lithium battery (CR2025) (1)
The battery is already installed. Before
using the remote commander, remove the
insulation film.
AC power cord (1)
Mini D-sub 15 pin cable (1)
Lens cap (1)
Carrying case (VPL-EX100/EX120 only)
Quick Reference Manual (this manual) (1)
Operating Instructions (CD-ROM) (1)
Insert the supplied CD-ROM into the
CD-ROM drive of your computer, and the
CD-ROM will start automatically in a few
moments. Select the Operating Instructions
you want to read. If the CD-ROM does not
start automatically, open the “index.htm”
file on the CD-ROM.
You must have Adobe Acrobat Reader 5.0
or higher installed in your computer to read
the Operating Instructions stored on the
CD-ROM.
1
Pull out the lithium battery
compartment.
Pull out the battery compartment with a
stick as shown in the illustration.
2
Insert a lithium battery.
3
Close the lithium battery
compartment.
CAUTION
Danger of explosion if battery is incorrectly
replaced.
Replace only with the same or equivalent
type recommended by the manufacturer.
When you dispose of the battery, you must
obey the law in the relative area or country.
Using the CD-ROM Manuals
Installing Batteries
With the 3 (plus)
side facing up.