Sony STR-DE185 - Manual (Page 22)

22
GB
The remote does not function.
• Point the remote at the remote sensor g on the
receiver.
• Remove any obstacles in the path between the
remote and the receiver.
• Replace both batteries in the remote with new
ones, if they are weak.
• Make sure you select the correct function on the
remote.
• If the remote is set to operate the TV only, use
the remote to select a source or component other
than TV before operating the receiver or other
component.
Clearing the receiver’s memory
To clear See
All memorized settings page 11
Specifications
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
With 8 ohm loads, both channels driven, from
40 – 20,000 Hz; rated 100 watts per channel
minimum RMS power, with no more than
0.09 % total harmonic distortion from 250
milliwatts to rated output (Models of area code
U only).
Amplifier section
POWER OUTPUT
Models of area code U
Rated Power Output at Stereo Mode
(8 ohms 40 Hz – 20 kHz, THD 0.09 %)
100 W + 100 W
Models of area code CEL, CEK
Rated Power Output at Stereo Mode
(8 ohms 1 kHz, THD 0.7 %)
100 W + 100 W 1)
1) Measured under the following conditions:
Area code Power requirements
CEL, CEK 230 V AC, 50 Hz
Frequency response
CD, MD/TAPE,
VIDEO 1, VIDEO 2
Inputs (Analog)
CD, MD/TAPE,
VIDEO 1, VIDEO 2
2) INPUT SHORT.
3) Weighted network, input level.
Outputs
MD/TAPE, VIDEO 1
Bass Boost: +8 dB at 70 Hz
Tone: ±10 dB at 100 Hz and
10 kHz
Voltage: 250 mV
Impedance: 10 kilohms
20 Hz – 50 kHz
+0/–0.5 dB (with bass
boost bypassed)
Sensitivity: 250 mV
Impedance: 50 kilohms
S/N
2) : 85 dB
(A, 250 mV 3) )
Troubleshooting (continued)