Sony PEG-TH55 - Manual (Page 12)

12
Sony Personal Entertainment Organizer PEG-TH55 US A-BU7-100-11 (1)
Troubleshooting
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
My CLIÉ handheld does not work
properly
B Is the POWER/HOLD switch of your CLIÉ handheld in HOLD mode?
Your CLIÉ handheld does not work when the POWER/HOLD switch is in
HOLD mode. Make sure you release HOLD mode.
Note
If you press the application buttons, Data Assistant button, or CAPTURE button, or slide down
the VOICE REC switch, or open the camera lens cover during HOLD mode, the POWER LED
blinks 3 times. However, your CLIÉ handheld does not operate.
B Has the battery power of your CLIÉ handheld run out?
Connect your CLIÉ handheld to the AC power adapter with the plug
adapter, then allow it to be charged for a few minutes before turning it on. If
it turns on, continue charging for approximately five hours and then perform
a soft reset by pressing the RESET button of your CLIÉ handheld.
b For details, refer to “Basic operations of your CLIÉ
™
handheld: Restarting your
CLIÉ
™
handheld” in the supplied “Read This First (Operating Instructions)”.
B Is the connector between your CLIÉ handheld and the plug adapter dirty?
You cannot charge your CLIÉ handheld if the connector is dirty. Connect
and disconnect your CLIÉ handheld and the plug adapter several times to
clean the connector.
B Perform a soft reset by pressing the RESET button of your CLIÉ handheld.
b For details, refer to “Basic operations of your CLIÉ
™
handheld: Restarting your
CLIÉ
™
handheld” in the supplied “Read This First (Operating Instructions)”.
B Is the POWER/HOLD switch of your CLIÉ handheld in HOLD mode?
The screen is not displayed when the POWER/HOLD switch is in HOLD
mode. Make sure you release HOLD mode.
I cannot turn on my CLIÉ handheld
The screen is not displayed even though the POWER
LED is on