Adder Technology AdderView CATx EPS-S8 - Manual (Page 62)
















Host selection
The.Hosts.button.on.the.menu.bar.provides.the.quickest.and.most.efficient.way.
to.switch.between.host.computers..This.is.because.the.button.is.close.at.hand,.
but.also.because.the.screen.calibration.details.for.each.host.are.reused.when.
this.method.of.switching.is.used..The.alternative.is.to.use.
hotkey combinations .
or.the.AdderView.CATx.IP. on-screen menu .
Note: The Hosts button is displayed only when the
switching details for two or more computers have
been declared within the configuration section by the
admin user.
To select a host
1. Click.the.Hosts.button.to.display.a.list.of.computers.
2. Click.the.required.computer.name.to.view.and.control.it.
See. Appendix 2 - Host configuration .for.details.about.programming.new.
hosts.into.the.AdderView.CATx.IP.(‘admin’.user.status.required).
Configure
This.option.is.displayed.only.when.you.are.logged.on.as.the.‘admin’.user..When.
selected.it.provides.access.to.a.wide.range.of.AdderView.CATx.IP.settings.
See.
Appendix 2 - Configuration pages via viewer .for.more.details.
Mouse pointers
Both.viewers.provide.a.double.mouse.cursor.to.help.overcome.any.delays.
caused.by.slow.connections..When.you.move.your.mouse.you.will.see.two.
mouse.cursors,.a.local.one.that.responds.immediately.to.your.movements.and.a.
second,.slower.moving,.cursor.that.represents.the.current.mouse.position.at.the.
host.
For.the.browser.viewer,.the.local.
cursor.is.a.typical.arrow:
For.the.VNC.viewer,.the.local.
cursor.is.a.dot:
Local dot cursor
Remote host cursor
Local cursor
Remote host cursor
Additionally,.for.fast.network.
connections,.the.VNC.viewer.also.
provides.a.single.mouse.mode..
See.
Controls - Single Mouse .for.
details...
Single local cursor