Adder Technology AdderView CATx EPS-S8 - Manual (Page 83)
















Clearing IP access control
This.option.removes.all.entries.from.the.IP.access.control.feature.within.the.
AdderView.CATx.IP.
What is IP access control?
The.IP.access.control.feature.(configurable.by.a.remote.admin.user).allows.
certain.network.address.ranges.to.be.denied.access.to.the.AdderView.CATx.IP..
If.set.incorrectly,.it.is.possible.to.exclude.all.network.users.and.so.this.option.
provides.an.emergency.recovery.point.
To clear IP access control
1. From.a.local.or.remote.(not.accessible.from.a.global.keyboard),.log.on.as.the.
‘admin’.user.
2. Press. . . .(hotkeys.can.change).
3. Press. .to.select.‘More.menus’.
4. Select.‘Functions’.
5. Select.‘Configure.IP.port’.
6. Select.‘Network.Configuration’.
Reset Configuration
This.option.allows.you.to.completely.reset.the.IP.portion.of.the.AdderView.CATx.
IP.unit..
WARNING: This process will remove all network and modem/ISDN settings
and return the unit to use its original state. A complete reconfiguration will be
required before the IP features of the unit can be used.
To reset the AdderView CATx IP configuration
1. From.a.local.or.remote.(not.accessible.from.a.global.keyboard),.log.on.as.the.
‘admin’.user.
2. Press. . . .(hotkeys.can.change).
3. Press. .to.select.‘More.menus’.
4. Select.‘Functions’.
5. Select.‘Configure.IP.port’.
AdderView CATx IP Reset Config
DO YOU WISH TO CONTINUE?
Cancel RESET
WARNING: Continuing will cause
your existing configuration to
be erased.
The unit will then reset and
require re-configuring before
it can be used.
6. Select.‘Reset.Configuration’.
7. Highlight.the.‘RESET’.option.and.press.
.
8. Access.the.‘Configure.IP.Port’.option.to.view.the.initial.IP.configuration.
screens..See. Initial IP configuration .for.details.
AdderView IP Network Config
Net Mask 255.255.255.0
192.168.42.154
No
Gateway
VNC Port
HTTP Port
5900
80
Clear IP Access Control
Cancel Save
IP Address
00:0F:58:00:00:04
Use DHCP
MAC Address
7. Highlight.the.‘Clear.IP.Access.Control’.option.and.press. .