Sony DCR-TRV950 - Manual (Page 99)

99
Editing
Dubbing only desired scenes – Digital program editing (on tapes)
MENU
3
4
7 5
OTHERS
DATA CODE
BEEP
COMMANDER
DISPLAY
VIDEO EDIT
RETURN
RETURN
TAPE
MEMORY
VIDEO EDIT
MARK
UNDO
ERASE ALL
START
EDIT SET
IR
0:08:55:06
TOTAL 0:00:00:00
SCENE 0
[MENU] : END
VIDEO EDIT
EDIT SET
CONTROL
ADJ TEST
”CUT–IN”
”CUT–OUT”
IR SETUP
PAUSEMODE
IR TEST
RETURN
IR
0:08:55:06
[MENU] : END
VIDEO EDIT
MARK
UNDO
ERASE ALL
START
EDIT SET
1 IN
0:08:55:06
TOTAL 0:00:00:00
SCENE 0
[MENU] : END [MENU] : END
OTHERS
DATA CODE
BEEP
COMMANDER
DISPLAY
VIDEO EDIT
RETURN
READY
[MENU] : END
VIDEO EDIT
EDIT SET
CONTROL
ADJ TEST
”CUT–IN”
”CUT–OUT”
IR SETUP
PAUSEMODE
IR TEST
RETURN
3
0:08:55:06
[MENU] : END
VIDEO EDIT
EDIT SET
CONTROL
ADJ TEST
”CUT–IN”
”CUT–OUT”
IR SETUP
PAUSEMODE
IR TEST
RETURN
IR
i. LINK
0:08:55:06
[MENU] : END
Step 2: Setting the VCR to operate with the A/V connecting cable
To edit using the VCR, send the control signal by infrared rays to the remote sensor on
the VCR.
When you connect using the A/V connecting cable, follow the procedure below, steps
(1) to (4), to send the control signal correctly.
(1) Set the IR SETUP code
1 Set the POWER switch to VCR on your camcorder.
2 Turn the power of the connected VCR on, then set the input selector to LINE.
When you connect a video camera recorder, set its power switch to VCR/VTR.
3 Press MENU, then turn the SEL/PUSH EXEC dial to set VIDEO EDIT in to
TAPE, then press the dial (p. 217).
4 Turn the SEL/PUSH EXEC dial to select EDIT SET, then press the dial.
5 Turn the SEL/PUSH EXEC dial to select CONTROL, then press the dial.
6 Turn the SEL/PUSH EXEC dial to select IR, then press the dial.
7 Turn the SEL/PUSH EXEC dial to select IR SETUP and turn the dial to select
IR SETUP code number of your VCR, then press the dial.
Check the code in “About IR SETUP codes.” (p. 100)