Sony CDX-GT72W - Manual (Page 10)

10
Customizing the equalizer curve
— EQ3 Tune
“Custom” of EQ3 allows you to make your own
equalizer settings.
1
Select a source, then press the multi
way encoder.
2
Rotate the multi way encoder to select
“EQ3 parametric,” then press it.
3
Rotate the multi way encoder to select
“Custom,” then push it right.
4
Rotate the multi way encoder to select
“EQ3 Mode Tune,” then press it.
5
Rotate the multi way encoder to select
the desired frequency range from
“LOW,” “MID” or “HI,” then press it.
6
Rotate the multi way encoder to select
the center frequency you wish to
adjust, then press it.
Selectable frequency in each range:
LOW: 60 Hz or 100 Hz
MID: 500 Hz or 1.0 kHz
HI: 10.0 kHz or 12.5 kHz
7
Rotate the multi way encoder to adjust
the equalizer curve.
The volume level is adjustable in 1 dB steps,
from –10 dB to +10 dB.
8
Press the multi way encoder.
Repeat steps 5 to 8 to adjust other frequency
ranges.
9
Push (BACK) down twice.
The display returns to normal play/reception
mode.
To restore the factory-set equalizer curve,
select “EQ3 Mode Initialize” and “Yes” in
step 4.
Tip
Other equalizer types are also adjustable.
Adjusting setup items — MENU
1
Press and hold the multi way encoder.
2
Rotate the multi way encoder until the
desired menu item appears, then
press it.
3
Rotate the multi way encoder to select
the setting, then press it.
The setting is complete.
4
Push (BACK) down.
The display returns to normal play/reception
mode.
The following items can be set (follow the page
reference for details):
“
z
” indicates the default settings.
Setup
Display
Clock Adjust (page 4)
Beep
To set “on” (
z
) or “off.”
RM (Rotary Commander)
To change the operative direction of the rotary
commander controls.
– “NORM” (
z
): to use the rotary commander in
the factory-set position.
– “REV”: when you mount the rotary
commander on the right side of the steering
column.
Auto Off
To shut off automatically after a desired time
when the unit is turned off: “NO” (
z
), “30 sec,”
“30 min” or “60 min.”
Demo (Demonstration)
To set “on” (
z
) or “off.”
Image
To set various display images.
– “Movie 1 (
z
) – 3”: to display a movie.
– “SA 1 – 3”: to display the Spectrum Analyzer.
– “Wall.P 1 – 3”: to display a wallpaper.
– “off”: to not display any image.
Auto Image
To set various display images.
– “All”: to step repeatedly through the display
images in all display modes.
– “Movie” (
z
): to display a movie.
– “SA”: to display the Spectrum Analyzer.
– “off”: to not display any image.