Safety precautions, Placement information, Safety information – Audiovox FPE1908 User Manual

Page 2: Condensation information, Rating plate location, Fcc statements

Advertising
background image

E - 2

SAFETY PRECAUTIONS

The lightning flash with arrowhead symbol,

within an equilateral triangle, is intended to

alert the user to the presence of uninsulated

“dangerous voltage” within the product’s enclosure

that may be of sufficient magnitude to constitute a

risk of electric shock to persons.

The exclamation point within an equilateral

triangle is intended to alert the user to

the presence of important operating and

maintenance (servicing) instructions in the literature

accompanying the appliance.

WARNING : TO REDUCE THE RISK OF ELECTRIC

SHOCK, DO NOT REMOVE COVER (OR BACK).

NO USER SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE

PERSONNEL.

CAUTION

• DANGER OF EXPLOSION IF BATTERY IS

INCORRECTLY REPLACED. REPLACE ONLY

WITH THE SAME OR EQUIVALENT TYPE.

• TO PREVENT ELECTRIC SHOCK, MATCH

WIDE BLADE OF PLUG TO WIDE SLOT OF

WALL OUTLET, THEN FULLY INSERT.

WARNING :

• TO PREVENT FIRE OR SHOCK HAZARD,

DO NOT EXPOSE THIS UNIT TO RAIN OR

MOISTURE. DO NOT PLACE OBJECTS FILLED

WITH LIQUIDS ON OR NEAR THIS UNIT.

• SHOULD ANY TROUBLE OCCUR, DISCONNECT

THE AC POWER CORD AND REFER SERVICING

TO A QUALIFIED TECHNICIAN.

PLACEMENT INFORMATION

• Do not use this unit in places that are extremely

hot, cold, dusty or humid.

• Do not restrict the airflow of this unit by placing it

somewhere with poor airflow, by covering it with

a cloth, by placing it on bedding or carpeting.

SAFETY INFORMATION

• When connecting or disconnecting the AC power

cord, grip the plug and not the cord itself. Pulling

the cord may damage it and create a hazard.

• When you are not going to use the unit for a long

period of time, disconnect the AC power cord.

CONDENSATION INFORMATION

• When left in a heated room where it is warm and

damp, water droplets or condensation may form

inside the equipment. When there is condensation

inside the unit, the unit may not function normally.

Let the unit stand for 1-2 hours before turning the

power on or gradually heat the room and let the

unit dry before use.

RATING PLATE LOCATION

The rating plate is located on the rear of the unit.

FCC STATEMENTS

NOTE: This unit has been tested and found to comply

with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against

harmful interference in a residential installation.

This unit generates, uses and can radiate radio

frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful

interference to radio communication. However, there

is no guarantee that interference will not occur in a

particular installation. If this unit does cause harmful

interference to radio or television reception, which

can be determined by turning the unit off and on, the

user is encouraged to try to correct the interference

by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the unit and

receiver.

- Connect the unit into an outlet on a circuit different

from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV

technician for help.

WARNING: Changes or modifications to this unit

not expressly approved by the party responsible

for compliance could void the user authority to

operate the unit.

The symbol for Class II

(Double Insulation)

English.indd 2

6/11/2008 12:36:03 PM

Advertising