Audiovox FPE1908 - Manual (Page 4)

E - 4
QUICK INSTALLATION
TURNING ON THE UNIT FOR THE FIRST TIME
The first time you turn on the unit, the unit will enter the setup mode. You can easily follow the prompt
message on the screen to complete basic TV settings.
1. Press the / button to select Yes. Press
the ENTER button to proceed with the initial
setup.
2. Use the / button to select Antenna, then
press the / button to select Air or CATV.
3. Use the / button to select Auto Scan, then press the button to enter auto scan menu. Use the /
button to select Start to Scan, press the button to begin scanning. (If you selected CATV on Step 2,
you need to select Cable System before Start to Scan). The system will automatically start to scan and
preset all available TV channels.
4. After scanning has finished the system will return to the first TV channel scanned.
Make sure the RF aerial has
been connected properly to the
TV ANTENNA input jack on the rear
of the system.
2 3/8"
2 3/8"
2 3/8"
When you turn on your television set for the first
time, be sure to place it on a solid stable surface.
To avoid danger, do not expose the TV to water,
or a heat source (e.g. lamp, candle, radiator).
Do not obstruct the ventilation grid at the rear
and be sure to leave sufficient gaps around the
unit as shown.
:SELECT
Proceed with auto scan ?
No Yes
"ENTER":CONFIRM
PICTURE AUDIO TIME SETUP PARENTAL TV
RF CH
Found 16
0
:
:
PRESS <MENU> TO EXIT AUTO SCAN
PICTURE AUDIO TIME SETUP PARENTAL TV
Cable System
Start to Scan AUTO
UP/DOWN ADJUST "MENU":EXIT
PICTURE AUDIO TIME SETUP PARENTAL TV
Antenna
Auto Scan
Auto Scan Add CH
Channel Skip
Channel No.
Channel Label
DTV Signal
CATV
UP/DOWN ADJUST "MENU":EXIT
English.indd 4 6/11/2008 12:36:04 PM