Panasonic DMWMCTZ30E - Manual (Page 13)

13
VQT4C30
6
Inspect the O-ring one last time.
Check the following one more time:
≥
There is no dirt sticking to the O-ring.
≥
The O-ring has not come out.
≥ The O-ring is not twisted.
≥
There are no scratches or squashed parts on the O-ring.
Thoroughly wipe any grease off your hands with a dry cloth. Afterwards
wash thoroughly with fresh water.
7
Close the buckle.
≥
Check that no foreign materials are sticking to the outer surface of the O-ring or
the buckle on the front case and then close the Case.
∫ Notes
≥
To keep the Case completely airtight, do not scratch the surface of the O-ring that
comes into contact with the sides of the Case.
≥ Never use an O-ring that has been scratched or damaged by dirt etc. This will cause
water leakage.
≥
Each time you use the Case, remove the O-ring and check that there is no dirt,
sand, hair or other foreign materials in the O-ring groove and then apply a thin coat
of grease (supplied). If you apply too much grease, dirt and the dust may stick to the
O-ring causing water leakage.
≥
Be sure to bring a spare O-ring in case the O-ring that you are using becomes
damaged or scratched.


DMW-MCTZ30-VQT4C30.book 13 ページ ２０１２年１月１２日 木曜日 午前１０時５０分