American Dynamics ADC770 - Manual (Page 11)

E-11
17 [DC 12V, AC 24V] Power input terminals
To input DC 12V or AC 24V power.
18 [AUX, GND] Auxiliary Output Terminals
If any change occurs in the area that was
set on the MOTION DETECT screen, these
terminals output signals. (
੬ Page 31)
[Open-collector Low signal. Maximum
voltage 30V, Current 30mA.]
19 [Y/C OUT] Y/C output connector
This 4-pin connector outputs the luminance
and chrominance signal.
• Pin configuration of Y/C OUT connector
21 [POWER] Power indicator lamp
This lamp lights when power is supplied
to the camera.
22 [SYNC IN] Sync signal input connector
This BNC connector accepts the input of
an external sync signal such as a composite
video (VBS) or black burst (BB) signal.
When a sync signal is input into this
connector, the camera operation is
automatically synchronized with the
external sync signal.
To terminate this connector at 75Ω, turn
ON the EXT.TERM switch
14 .
Pin No. Signal
1 GND
2 GND
3 Luminance (Y)
4 Chrominance (C)
4
2
3
1
DC12V AC24V
Y/C OUT
SYNC IN
POWER
VIDEO OUT
SEE INST-
RUCTION
MANUAL
+ -
1 2
*
)
&
⁄
¤
REMOTE
AUX GND
CLASS 2 ONLY(U TYPE)
ISOLATED POWER ONLY
(E TYPE)
(
20 [VIDEO OUT] Video signal output
connector
This BNC connector outputs a composite
video signal. Connect this to the video input
connector of a video monitor, switcher, etc.
e02_adc770(06_22)e.p65 5/10/04, 10:41 AM 11