Panasonic NRB32SW1 - Manual (Page 14)

14 14
Maintenance check
● Is the mains lead damaged?
● Does the mains plug get hot?
● Is the mains plug firmly in the mains socket?
If the mains lead is damaged, please consult an authorized service centre. DO NOT attempt to
replace these items yourself.
WARNING
Extended disuse
If you’re not going to use the refrigerator for a long time, unplug it and clean the mains plug as
described above. Then leave the doors open for 2-3 days. This lets the interior dry out properly, and
prevents odour and the build up of mould.
Do not switch the refrigerator on and off repeatedly. It will last longer if you leave it switched on
during normal use.
CAUTION
Before moving or transporting your refrigerator
① Remove all items.
② Unplug it.
③ Raise the adjustable leg.
④ Pull, or ‘walk’ the refrigerator towards you.
⑤ Use a cloth, for example, to absorb the water in the evaporation pan.
(Lower back of the refrigerator)
When replacing the bulb, disconnect the mains plug from the mains socket.
Failure to do this could cause electric shock or injury.
WARNING
Replacing the bulb
① Disconnect the mains plug from the mains socket.
② Remove the bulb cover.
(See image on the right.)
③ Turn the bulb to the left and remove it.
Notes:
• Follow these procedures in reverse to install the replacement bulb.
• The replacement bulb must be maximum 15 W, 230 V and size E14.
Bulb cover
Moving and transporting your refrigerator
At least two people are needed to carry the refrigerator safely.
① Tighten the adjustable legs.
② Hold the adjustable legs at one end, and corners at the
other, as shown.
Note:
• Do not carry the refrigerator by holding its doors.
Always transport the refrigerator in its normal upright position.
Secure the doors with
adhesive tape
Care and Cleaning instructions
(continued)