Panasonic TYWK42PV20 - Manual (Page 13)

13
English
Fitting procedure
1. Assembling the wall-hanging
bracket
 Place the base upper and lower fittings
① and base left ② and right ③ fittings as
shown in the diagram.
 Insert the projecting parts (tabs) of the
base left and right fittings into the cutouts
of the base upper and lower fittings (two
positions on right, and two on left), and
secure the fittings with the screws for
assembling the fixtures ④ (two for each)
in the order of ❶ and then ❷ .
(Tightening torque: 1.2 to 1.5 N•m)
Bracket base
right fitting

Base upper and lower fitting 
❶ ❷ ❶ ❷
❷
❷ ❶ ❷ ❶
❶
Tab
Tab
Cutout
Bracket base
left fitting

Screw for assembling
the fixture
Base upper and lower fitting  Note
• Please hold the bracket base left and right
fittings as you work with the assembled wall
hanging bracket. Holding the base upper and
lower fittings might deform this unit.
2. Checking the strength of the
installation location
 The wall-hanging bracket weighs
approximately 2.3 kg (5.1 lbs).
Refer to the instruction manual of the
plasma display, and check the weight of the
plasma display unit which will be fitted into
the wall-hanging bracket.
 Refer to the outline drawing of the wall-
hanging bracket shown on the right,
and check the wall strength at the six
installation positions shown. If the strength
at any of these positions is lacking, provide
sufficient reinforcement.
Unit: mm (inches)
550 (21.7)
485 (19.1) 450 (17.8) 300 (1
1.9)
61.5 (2.5)
440 (17.4)
400 (15.8) 40 40
(1.6) (1.6)
Wall mounting holes (at 6 points)
Use the screws without fail to anchor the fixture.
Notes
• There are five pre-drilled mounting holes at the
top and another five at the bottom of the wall-
hanging bracket. Use the spare holes provided
if wood or some other material is used for the
wall and a sufficient level of mounting strength
cannot be ensured by anchoring the fixture at
the six positions shown on the right. However,
bear in mind that, depending on which materials
the mounting surface is made of, cracks may
form on the surface if the screws are used at
positions which are too close together.
• Do not mount or place any other product other
than the plasma display on the fixture.
• For details on the dimensions applying when the
plasma display is mounted, refer to the outline
drawing (See page 83-84).