Panasonic TYWK42PV20 - Manual (Page 16)

16
English
Fitting procedure
 Tighten up the screw for securing unit  , which was secured loosely in section 4, until it will go no further.
Note
• Tightening up the screw for securing unit  too much may cause the bracket to be bent out of shape.
 Lift the plasma display slightly, and check that it is firmly secured in place.
Horizontal installation
Screw for securing unit (long) 
(Tightening torque: 2.5 to 3.5 N•m)
Vertical installation
Removing the plasma display
 Place a soft blanket or piece of cloth underneath the plasma display.
Remove the screw for securing unit  which is attached to the side of
the wall-hanging bracket.
Horizontal installation Left or right side of wall-hanging bracket
Vertical installation Left side of wall-hanging bracket
Surface of wall
Lower
insulation
spacer
Screw for securing
unit 


Surface of wall
Blanket or
piece of cloth
Floor surface
Note
• Otherwise, the screw for securing unit  may drop down by mistake,
leaving marks on the surface of the floor.
 Disconnect the power cord and the wires connecting the plasma
display to the other units.
 While lifting the bottom part of the plasma display, pull the plasma
display toward you.
 After the bottom insulation spacers have been removed, continue
lifting up the plasma display and remove it.
Note
• The plasma display needs to be lifted up approximately 4 cm
(1.6 inches) to be removed.
Screw for securing unit (short) 
(Tightening torque: 1.2 to 1.5 N•m)